Same-Day Appliance Repair in Connecticut

A washer that won't spin is usually caused by a worn drive belt, a faulty lid switch or door latch, a broken motor coupling, or an overloaded drum. Less commonly it's the control board or motor. Our technician will diagnose the exact cause before recommending any repair.

Leaks typically come from a torn door gasket/boot seal (very common on front-loaders), a cracked water inlet valve, a damaged drain hose, or a worn tub bearing seal. The location of the leak (door, bottom, back) helps narrow it down quickly.

Possibly, but not always. On electric dryers, no-heat issues are most commonly a blown thermal fuse, a failed heating element, or a bad thermistor/thermostat. On gas dryers, the igniter or gas valve coils are the usual culprits. We test all components before replacing anything.

Squeaking is almost always the drum glides, drum bearing, or idler pulley wearing out. Thumping usually means a broken or stretched drum drive belt. Both are straightforward repairs that are typically completed in one visit.

This is a very common symptom of a failed evaporator fan motor or a defrost system problem (defrost heater, defrost thermostat, or defrost timer). The freezer keeps cooling because the compressor still works, but cold air isn't circulating to the refrigerator section. We see this frequently across Samsung, LG, and Whirlpool models.

Usually not. The most common causes are a failed ice maker assembly, a blocked or frozen water supply line, a faulty water inlet valve, or a stuck ice level arm. In most cases we can replace the failed component and restore ice production within a single visit.

A clicking noise often indicates a failing start relay or compressor having trouble starting — this needs prompt attention to avoid compressor failure. Buzzing is often the evaporator or condenser fan motor going bad. Neither should be ignored as they can escalate quickly.

Water under the crisper drawers is almost always a clogged defrost drain. As ice melts during the defrost cycle, it flows through a drain tube that can become blocked with food debris or ice. We clear the drain and verify the defrost system is working properly.

Poor cleaning performance is typically caused by clogged spray arms, a worn wash pump motor, a failed detergent dispenser, low water temperature, or a dirty filter assembly. We check all components — sometimes it's simply a clogged filter that homeowners can clean themselves, and we'll show you how.

Not necessarily — it's often the drain pump, but it could also be a clogged drain hose, a stuck check valve, or a garbage disposal connection issue. We diagnose the full drain system before replacing components.

A gas oven that clicks but won't light, or shows a gas smell without igniting, needs prompt professional attention. The most common causes are a failed igniter, a faulty spark module, or dirty/misaligned burner caps. If you smell a strong gas odor, leave the home and call your gas provider first, then contact us.

Uneven oven heating is usually caused by a failing bake element (electric) or a temperature sensor giving inaccurate readings. It can also be a control board issue. We test oven temperature across multiple zones to pinpoint the cause.